Solution To Fix Canon Printer Error Code p10
Added: (Tue Sep 29 2020)
Pressbox (Press Release) -
Canon printer have a few common problems that occur frequently. One of them is the Canon printer Error Code P10. If the display of your Canon PIXMA shows the Canon Printer error P10 and the orange and green LEDs flash 10 times, then there is a service error. Correct this as described in the following instructions.This error is displayed on your printer system when the print head temperature is above the specified value. In these cases, you need to opt for expert opinion. Our tech experts know the different aspects of a printer so they can apply adequate methods and tools to resolve them.
Canon Printer Error P10 Code is an error code that appears due to physical damage to the printer mainboard. In this P10 error, the handling must replace the damaged component. In general, the defective component that causes error P10 is the resistor.
The following is the sequence of steps to Overcome the Canon Printer Error P10, beforehand prepare the following tools and materials:-
Soldering iron
Lead
Flux
tweezers
Resistors
Screwdriver + and-
Here are the steps that must be done:-
1. Open the casing to the right printer, starting with the opening cover by prying the buttons using a screwdriver.
2. Then loose screws inside (below the buttons that are already open lid earlier)
3. After the screw is released, open the right side of the printer body case with a screwdriver. 4. Then remove the cables attached to the mainboard, do it carefully.
5. Find the resistor component code R301 and R302.
6. Then to remove the resistor, apply flux first but not too much.
7. Then solder, but beforehand give a little tin on the tip of the solder
8. After removing it, replace it with a new resistor.
9. To facilitate the installation of lead resistors first.
10. After that install the resistor
11. The resistor has been replaced
12. Then plug the mainboard back into the printer and plug the cables back in so that they don't turn upside down.
13. Plug in the power cable and USB, then turn it on. If the number 1 appears, it means that the error p10 has been resolved.
14. Printer back to normal and replace the printer body casing and button cover.
Get More:- https://www.canonprintersupport247.com/blog/how-to-fix-canon-printer-error-code-p10/